To lock the slide lock from the outside you need to install a lock handle with the spindle inserted into the square hole next to the operating lever.
How to fix manual garage door lock.
Locate where the ends of the locking bars hit the track and miss the hole.
Pull the handle away from the face of the door and spray a generous amount of lubricant on the inner.
Put the bolt ends through the holes in the garage door rail.
Loosen the machine screws on the handle base plate using the appropriate screwdriver.
The locking bar is keeping the door locked.
The second set of nuts can then be hand tightened to hold the lock onto the rail.
Once installed turn the handle 90 degrees to lock the slide lock.
Garage door repair is can be costly but these basic tips will keep your garage door running smoothly all year long.
So the garage tilt a door lock has been ripped out.
Step 3 loosen the screws that secure the locking bar guides at each end of the door panel with a 3 8 inch socket wrench.
Step 2 remove the pin that secures the inside lock handle to the lock shaft in the center of the door panel.
Garage doors won t open refuse to lock or age and warp.
Close the garage door and attempt to lock the door from the inside.
Place the vice grips on the door track above any door roller and lock the vice grips on the track.
Close the garage door and secure the door down with a pair of vice grips.
The door is now locked.
This will turn the operating lever and extend the bolt into the locked position.